PERFORMA AUDIO . Amplifier . ZP Series . ZP 9800

ZP 9800

Ultra stable pwm (pulse width modulated) mosfet power supply
2 ohm stable operation with output power increase
built-in crossover top control
ch ½: variable hi-pass filter (40hz-1khz)
          variable low-pass filter (40hz-250hz)
          variable sub-sonic filter (15hz-40hz)
ch ¾: variable hi-pass filter (40hz-1khz)
          variable low-pass filter (40hz-250hz)
          variable sub-sonic filter (15hz-40hz)
tri-mode cap ability for simultaneous hook-up of two stereo channels and subwoofer
crossover mode switch (hi, full, low)
soft-start delay turn-on circuit
wired remote control
automatic remote on/off switching
power on and protect led indicators
bult-in overload protection circuit
bult-in over current protection circuit
bult-in overheat protection circuit
gold plated rca input and transparent terminals
line out rca jack

Technical Specification

4 ohms maximum output @0.03% THD	1000Watts
4ohms bridged mono output @0.02% THD	2 x 500W
2 ohms WRMS output @0.1 THD	4 x 250W
Low pass filter	40Hz - 250Hz
High pass filter	----
Subsonic Filter	15Hz-40Hz/Subsonic
Frequency response	10 - 40000Hz
Signal to noise ratio	100dB
Stereo separation	>55dB
Input sensitivity	145mV-2.4V
Input impedance	10 Kohms
Operation voltage	DC 12V
Speaker impedance @ stereo driven	4 Ohms
Remote Control	Optional
Fuse rating	20Ax3
Dimension (WHD) mm	380x50x244